Main applications of cationic polyacrylamide emulsion (ZETAG 9248FS PREASTOL K 233)

PREASTOL K 233 is a cationic polyacrylamide emulsion with very high  charge, zetag 9248FS is a cationic polyacrylamide emulsion with 50-60% charge, mainly used for wastewater treatment and sludge dewatering.

With acrylamide and cationic quaternary ammonium salt as monomer, inorganic salt solution as dispersant, developed from cationic quaternary ammonium salt polymer cationic polyacrylamide emulsion products. Due to the macromolecule material produced by the particle size of micron level, spherical suspension in the dispersed medium, between molecules do not adhere to each other, so the effective concentration is high, good liquidity, can quickly dilute to use concentration without agglomeration phenomenon. Low apparent viscosity, good fluidity, easy to dissolve; Strong adaptability, can be used in a wide range of pH, not affected by other salts, no pungent smell; Characteristics that do not produce secondary pollution. This product does not contain oil agent and surfactant.

Acrylamide emulsion is widely used in chemical wastewater, oilfield wastewater, sludge dewatering treatment, papermaking wastewater, domestic sewage treatment, brewery, amylase factory, food processing plant and other sewage treatment. It is especially suitable for flocculation and sedimentation of organic suspended solids in acidic or acidic sewage.

Latex type polyacrylamide method of use

1) Before using cationic polyacrylamide emulsion products, shake well as far as possible;

2) When dissolved, water and product are added at the same time. The recommended solution concentration is 1-5‰ and the ripening time is 15-25 minutes.

3) avoid the use of centrifugal pump and other high shear rotor pump, the best use of low shear pump such as screw pump;

4) Dissolution operation should be carried out in plastic, ceramic, stainless steel and other materials in the tank, mixing speed should not be too large, without heating.

5) The dilute solution prepared should not be stored for a long time and should be dissolved with use;

6) polyacrylamide emulsion with inorganic coagulant treatment of wastewater, should be added first inorganic coagulant. When the flocculated alum flower occurs (generally about 30-60 seconds interval), the product cannot be added at the same time.

Latex polyacrylamide use matters needing attention

1) In the use of polyacrylamide emulsion must wear protective equipment, skin contact parts should be cleaned immediately.

2) The operation site should be cleaned up in time to prevent slipping.

Polyacrylamide emulsion storage matters needing attention

1. Under normal temperature, the storage period is generally 6 months in a closed container, and pay attention to avoid light;

2, small barrels in storage should pay attention to regular turnover, shaking, to achieve full agitation, prevent stratification;

3. When storing in large containers, install a multi-leaf stirring that can be stretched to the bottom of the container, open regularly, or install a circulating pump, circulate regularly to ensure full stirring and prevent stratification.

4, excellent storage temperature is 10-27°C, the product can not be frozen, otherwise it will affect its performance.

5, if the product once there is icing phenomenon, to move to a higher temperature place, make it slowly defrost, before use to fully mix, and 100 mesh sieve.

Polyacrylamide emulsion packaging and transportation:

1, 25 kg plastic drum, 200 kg plastic drum or ton drum packaging.

This product is non-dangerous goods.